User's Manual

Document is the property of LDL-Technology and cannot be
reproduced or transmitted without written consent
WUS MOTO Mounting process mode
Ref : C 307 020 0010
Version : E2
C3070200010-E2-WUS Mounting process mode.odt LDL Technology SAS
10/ 24 Toulouse – France
Copyrights 2016
While pushing on the
nut, keep it centred on
the valve hole ; then
introduce the valve in
the valve hole.
While you are still pushing
on the nut start screwing the
valve manually still the seal
get in touch with the rim.
AVOID ANY SCREWING IF PLASTIC HOUSING
IS IN CONTACT WITH THE RIM
(the introduction of a piece of paper (80gr/m²) between the rim and the
plastic parts make you sure that there is no contact).
Step N°4
Step N°5
Step N°3
- Screw the nut with a allen key
(5mm). Do note exceed 2 rounds
per second.
- Final torque 5 Nm +/- 0.5 Nm.