Users Manual

INFRARED SYNCHRONISATION (IR SYNC RUN)

To synchronise the pocket receiver with the radio frequency set in the transmitter and the individual user nam

e, bring the infrared interface of the

receiver into direct visual contact with the infrared interface of the transmitter (distance approx. 10 cm) and switch on the receiver. Now press the

rotary-push encoder of the transmitter (MENU) to enter the main menu and select IR SYNC RUN (highlighted) by turning the encoder. Press MENU

again to start the synchronisation process. After a few seconds the process is completed and the display of the receiver changes for a short time

to “IR SYNC ”, thereby conrming successful synchronisation. To cancel the operation, press MENU. Briey (!) press POWER to return directly to the

main display; after about 12 seconds of inactivity the main display will appear automatically. Please note: Direct sunlight can interfere with the

synchronisation process.

RADIO UNIT CONFIGURATION (RF SETTINGS)

Press the transmitter's rotary-push encoder (MENU) to enter the main menu, then turn the encoder to select RF SETTINGS (highlighted). Press the

encoder again to enter the sub-menu and select the desired sub-menu item by turning the encoder, then conrm by pressing the encoder. If you

change a value by turning the encoder, conrm the value change by pressing the encoder. The sub-menu items and the corresponding information

can be found in the following table. Briey (!) press POWER to return directly to the main display; after about 12 seconds of inactivity the main

display will appear automatically.

RF SETTINGS (change value = turn encoder, conrm value change = press encoder)

GROUP U5047IEM frequency group 1

U5051IEM frequency group 1

U505IEM frequency groups 1 – 10

U506IEM frequency groups 1 – 10

U508IEM frequency groups 1 – 8

Select group and conrm 2x

CHANNEL Frequency channel 1 – 12 Select channel and conrm 2x

DEUTSCHFRANCAIS

ESPAÑOL

ENGLISH

ITALIANO POLSKI