User manual

6
Handling Tips
If equipment is taken from a cold climate into a warm room, water can
condense onto the cold metal and cause short circuiting and damage to the
components. Do not connect to the mains, or switch on the power until the
equipment has reached room temperature!
Do not handle the power cable with wet hands!
Never pull the plugs out of equipment by the cable. Always grip the moulded
casing.
Extended exposure to overly loud music can cause damage to your hearing.
Maintenance
Check regularly for any signs of wear or damage to the equipment and especially all cables.
Do not use the equipment if it is obviously defective and ensure that no-one else can
inadvertently operate it. Remove the power cable!
The equipment should not be used when:
• the equipment is obviously damaged.
• the equipment does not work anymore.
• the equipment has been stored under poor conditions.
Please observe the following safety precautions before maintenance or cleaning :
Opening up the equipment or removing parts can leave electrical components
exposed.
If the equipment is opened up, make sure the power switch is Off and the
power cable is completely unplugged.
Although there is no power connected to the equipment, there remains a
possibility of an electrical shock from condensers, which hold their charge
even after the power has been switched off.
Repairs should only be carried out by qualified personnel.
Cleaning
• Clean only with a dry cloth or brush.
• Do not use any harsh detergents or chemicals, as these can damage the surfaces.
Fuse
Use only the correct size of replacement fuse.(see Specifications).
Do not temporarily or permanently bridge the fuse with wire or silver foil!
Remove the power cable from the rear of the Active Monitor and pull the fuse
holder cap until the fuse is exposed. Replace only with the correct fuse (see
Specifications), then press the holder back in place.