Manual
2
7. Do not oil cartridges and be sure to
wipe the chamber clean of any oil or
preservative before commencing to shoot.
Oil interferes with the friction between car-
tridge case and chamber wall that is nec-
essary for safe functioning, and subjects
the firearm to stress similar to that
imposed by excessive pressure.
8. Use lubricants sparingly on the moving
parts of your firearm. Avoid excessive
spraying of any aerosol gun care product,
especially where it may get on ammuni-
tion. All lubricants and aerosol spray lubri-
cants in particular, can penetrate cartridge
primers and cause misfires. Some highly
penetrative lubricants can also migrate
inside shell cases and cause deterioration
of the propellant powder; on firing, the
powder may not ignite. If only the primer
ignites, there is danger that the wad may
become lodged in the barrel.
•WARNING: Discharging firearms in
poorly ventilated areas, cleaning
firearms, or handling ammunition may
result in exposure to lead and other sub-
stances known to cause birth defects,
reproductive harm, and other serious
physical injury. Have adequate ventila-
tion at all times. Wash hands thoroughly
after exposure.
Assembly
In order to attach the barrels to the receiv-
er, the ejectors must be positioned out of
the chambers (see A). To accomplish this,
push the forward end of the ejectors rear-
ward with a screwdriver (see B), and
mount the barrels and forearm.
How to Operate the Safety
Prior to firing, know and understand the
operation of the safety by practicing with
the shotgun unloaded.
The safety is a rectangular switch located
on the tang of the action, directly behind
the top lever of the shotgun, which slides
forward and backward. When the switch is
at the rear end of its travel, the letter
“S”appears immediately in front of the
switch (see C). This means the shotgun
will not fire when the trigger is pulled.
When the switch is in its forward-most
position, the “S” is covered. This means
the shotgun is NOT ON SAFE and will fire
when the trigger is pulled (see D).
Safety ON
C
Screwdriver
Ejectors
A
In order to attach the barrels to the receiver, the
ejectors must be positioned out of the chambers.
Screwdriver
Ejectors
B
Push the ejectors rearward with a screwdriver
to position them out of the chambers.