Instruction Manual

ManualsBrandsLBL Lighting ManualsLightingVision

Installation Instructions for

Vision Wall

1.3

HW336_1A35

980VISIOW

GENERAL PRODUCT INFORMATION:

This product can mount to either a 4" square electrical box with

round plaster ring or an octagon electrical box.

This product is suitable for indoor dry locations only.

This product can be dimmed with a standard incandescent dimmer.

Install the Fixture

M3 SET SCREW

1.5MM ALLEN WRENCH

BACKPLATE

CANOPY

Loosen (Do Not Remove) the two M3 set screws on side of

the canopy with the 1.5MM Allen wrench provided.

Remove the backplate.

Connect the transformer white wire to the neutral power line

wire with a wire nut.

Connect the transformer black wire to the hot power line

wire with a wire nut.

Place the transformer inside the electrical box. Use the

attached sticky pad to secure it against the electrical box.

STICKY PAD

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Wall

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980VISIOW Vision Wall HW336_1A35 1.3 Wall GENERAL PRODUCT INFORMATION: 1 This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. This product is suitable for indoor dry locations only. This product can be dimmed with a standard incandescent dimmer.
PAGE 2
1C 1E #8-32 SCREW M3 SET SCREW 6 7 8 11 BACKPLATE 11 7 ELECTRICAL BOX HOLE CANOPY 6 Line up two backplate holes with the electrical box holes. 7 Mount the backplate to the electrical box with the two #8-32 screws provided. 8 In accordance with local electrical codes, make sure that the backplate and the transformer green wire are grounded. 11 1D 9 9 9 Connect each transformer low voltage wire (red wire) to one fixture wire with a wire nut.
PAGE 3
Install the Lamp and Disk 2A 2B CRYSTAL GLASS DISK LAMP CURVED SECTION 2 ACCESSORY SPRINGS 1 SOCKET 2 CURVED SECTION 2 Use MAX 35 Watt MR11 Front Cover Halogen Lamp . 1 Align and push the lamp pins completely into the socket holes. 2 Orient the recessed section of the crystal glass disk towards the lamp. Place edge of the crystal glass disk into curved section of three accessory springs. NOTE: The Crystal glass disk must be removed when relamping.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2014 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.