Manual

ManualsBrandsLBL Lighting ManualsLightingTessa 8-Light S

Installation Instructions for

Tessa 6 and 8 Light Suspension

980TESSAS

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent.

Suspension

1.0

SU7578_

Install the Mounting Plate

Separate the mounting plate from the canopy by

removing all four screws.

SCREWSCREW

CANOPY

Remove the mounting plate from the canopy.

MOUNTING PLATE

SU7576_

MOUNTING

PLATE

Secure the mounting plate to the electrical box with the

two #8-32 screws provided.

#8-32 SCREW

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980TESSAS SU7576_ SU7578_ Tessa 6 and 8 Light Suspension 1.0 Suspension GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can be dimmed with a standard incandescent. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
Assemble the Fixture 1D 2A MOUNTING PLATE TOP STEM ANCHOR ANCHOR LONG STEM 4 Verify that the mounting plate is level before continuing. 5 Line up an anchor tip with the center of a mounting plate hole, and push the anchor into the ceiling up to the threads. 6 Screw the anchors in the rest of the way with a Phillipshead screwdriver. 7 6 Repeat steps 5-6 for the other anchor. 1 2 For full extension, screw a long stem onto each top stem section.
PAGE 3
Install the Fixture 2C 3A POWER CABLES 1 3 STEM 2 POWER CABLES NOTE: 6 light fixture only has one set of power cords. FIXTURE NOTE: 6 light fixture only has one set of power cords. 3 Feed the power cables from the fixture completely through the stems. 1 2 Connect the fixture to a suitable ground in accordance with local electrical codes. 2 Connect the black fixture wire(s) to the hot power line wire with a wire nut.
PAGE 4
Install the Lamps 4A Shade Versions Only 4B LAMP SHADE SOCKET 1 2 Gently place a shade over each lamp. C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. Use MAX 75 Watt medium base lamps. Versions with glass shades include S-21 Squirrel Cage type S-21 medium base lamps. or other style 75 Watt type A19 medium base lamps. Versions without glass shades include Soft White type A19 medium base lamps. 1 2 Screw the lamp into the socket.