User Manual

2
Install the Lamp
1D
1C
In accordance with local electrical codes, make sure that the
backplate is grounded.
Connect the fixture white wire to the neutral power line wire
with a wire nut.
Connect the fixture black wire to the hot power line wire with
a wire nut.
Place all wires and wire nut connections properly inside the
electrical box.
Place the fixture canopy onto the backplate. Level the fixture
vertically and tighten the two M3 set screws with the 1.5MM
Allen wrench to secure the fixture in place.
M3 SET SCREW
1.5MM ALLEN WRENCH
CANOPY
LAMP
SOCKET
NOTE: Use only your fingers and a soft cloth to install
the lamp.
Push the lamp pins completely into the socket holes.
Use 120 Volt, Watt Type T4,MAX 40
G9 Base, Bi-Pin Halogen Lamp.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
5
6
7
8
9
6
1
2A
1
7
9