User Manual

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWERTO THE

ELECTRICAL BOX OFF.

Fusion Jack™

Installation Instructions for

1.3

HS228_

980FSJSAMP

Use Watt,Type XelogenMAX 50

(Xenon) Bi-Pin Lamp.

Push the lamp pins completely into the socket holes.

NOTE: To reduce the risk of a burn or electric shock

during relamping, disconnect the power to the fixture.

NOTE: Use only your fingers and soft cloth to replace

the lamp.

SOCKET

ASSEMBLY

BRACKET

LAMP

GLASS SHADE

Slide the glass shade over the socket assembly bracket.

Align the glass shade holes with the socket assembly bracket

holes and secure it in place by tightening the three provided

pin screws.

PIN SCREW

Install the Lamp & Shade

SOCKET

WARNING: RISK OF FIRE

Never replace a Xenon (Xelogen) lamp with a regular

Halogen lamp.A regular Halogen lamp requires a protective

glass shield.

Sam

PAGE 1
Installation Instructions for 980FSJSAMP Sam HS228_ 1.3 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. CAUTION - RISK OF FIRE This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
Adjust the Fixture Height 2E 2A 6 ALLEN WRENCH SET SCREW CONICAL CONNECTOR 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench. 1 Feed and push the coaxial cable into the conical connector.The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector.
PAGE 3
2H 10 10 Firmly tighten the set screw on the conical connector. 2I 11 11 Pull the coaxial cable toward the fixture to smooth the wrinkles.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2013 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.