Manual

ManualsBrandsLBL Lighting ManualsLightingMILO SCH

Install the Mounting Plate

Installation Instructions for

Suspension

1.0

#8-32

SCREW

MOUNTING

PLATE

Mount the mounting plate assembly to the electrical box

with the two provided #8-32 screws.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Remove the mounting plate from the canopy by completely

unscrewing the mounting plate from the strain relief.

STRAIN RELIEF

CANOPY

Milo Suspension (Compact Fluorescent)

980MILOSCF

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This instruction shows a typical installation.

SU784_CF

MOUNTING

PLATE

2 2

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980MILOSCF Milo Suspension (Compact Fluorescent) SU784_CF 1.0 Suspension GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This instruction shows a typical installation. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
Assemble the Fixture Install the Fixture 2A 3A CANOPY SHADE SET SCREW CORD 1 Loosen (Do Not Remove) the set screw on the strain relief. 3B 2 SOCKET ASSEMBLY 1 CANOPY 3 CORD Feed the canopy, cord, and socket assembly through the shade. 2 Adjust the fixture height (from bottom of the fixture shade to top of the canopy) by moving the canopy and strain relief up or down. 3 When the desired height is achieved, tighten the set screw on the strain relief.
PAGE 3
D 3F 14 14 16 15 4" 13 13 6 Leave 6" of the cord behind the canopy for power connections. Cut the excess cord. 7 From the end of the cord, strip the insulation 4" using a sharp knife. Make sure not to nick the inner wires. 8 Strip the end of the wires. BALLAST 13 Reconnect the power cord wires to their original connections (reversal of 3C). 14 Connect the mounting plate and the fixture ground wire to a suitable ground in accordance with local electrical codes.
PAGE 4
Install the Lamp and Diffuser 4A 3F CORD SET SCREW STRAIN RELIEF CORD SOCKET ASSEMBLY SHADE 1 LAMP NOTE: It is recommended that one person hold the fixture while the electrician finishes the installation. 17 Place the ballast, all wires, wire nut connections, and the secondary strain relief properly inside the electrical box. 18 Loosen the set screw on the primary strain relief. 19 Align the canopy center hole with the mounting plate center hole.