User guide

ManualsBrandsLBL Lighting ManualsLightingLED Pendants

Installation Instructions for

LED Pendants

1.1

980FSLEDP

Fusion Jack™

Adjust the Fixture Height

Feed the fixture coaxial cable through the shade. Slide the

shade down the cord and rest it onto the socket assembly.

Cut the coaxial cable to the desired length with a sharp cutter.

The overall fixture height is measured from bottom of the

shade to end of the coaxial cable.

SOCKET ASSEMBLY

FIXTURE COAXIAL

CABLE

CONICAL CONNECTOR

FIXTURE COAXIAL CABLE

Insert the fixture coaxial cable through the conical connector.

STRAIN RELIEF

Insert the coaxial cable through the flared end of the strain

relief.

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

Fusion Jack LED Pendants

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980FSLEDP Fusion Jack LED Pendants LED Pendants 1.1 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Adjust the Fixture Height 1A CONICAL CONNECTOR 1B FIXTURE COAXIAL CABLE FIXTURE COAXIAL CABLE 3 3 Insert the fixture coaxial cable through the conical connector.
PAGE 2
1D 1G OUTER WRAPPED WIRE 2MM ALLEN WRENCH M4 SET SCREW 12 5 13 11 INNER WIRE STRAIN RELIEF 5 Slide the outer wrapped wire back to expose the inner wire. 11 The strain relief slots should be rotated 90° away from the M4 1E set screw. 2MM ALLEN WRENCH 12 Slide and push the strain relief completely into the connector. 1.5MM ALLEN WRENCH This will force the outer wrapped wire to be inserted into the connector.
PAGE 3
Replacing the Lamp NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. The lamp is rated at 6 watts at 12 volts. 2A 2C SHADE SOCKET 3 1 Lift the shade up to expose the socket. 3 Screw the new lamp into the socket. NOTE: Use only your fingers to replace the lamp. 2B 2D SHADE LAMP 2 3 4 4 Lower the shade onto the socket assembly. 2 Unscrew the old lamp.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2008 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.