Manual

Installation Instructions for

Henry 18 Outdoor

980TARA18O

Install the Fixture

GP I :ENERAL RODUCT NFORMATION

This product is suitable for wet locations.

This product can mount either to a 4” square electrical box with a

round plaster ring or an octagon electrical box.

This product may be dimmed with a low-voltage electronic dimmer.

With the Allen wrench provided, back out (do not fully

remove) the set screws at the base of the fixture.

Remove the mounting plate from the back of the

fixture.

Attach the mounting plate to the electrical box using

the two #8-32 screws provided.

MOUNTING

PLATE

#8-32 SCREW

ALLEN WRENCH

SET SCREW

MOUNTING

PLATE

1.0

Outdoor

1A 1B

OD821_

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

PAGE 1
Installation Instructions for 980TARA18O Henry 18 Outdoor OD821_ Outdoor GENERAL PRODUCT INFORMATION: This product is suitable for wet locations. This product can mount either to a 4” square electrical box with a round plaster ring or an octagon electrical box. This product may be dimmed with a low-voltage electronic dimmer.
PAGE 2
1C 1D SCREW WASHER ANCHOR ANCHOR WASHER SCREW 4 Verify that the mounting plate is level before continuing. 8 6 5 Line up an anchor tip with the center of a mounting plate hole, and push the anchor into the wall up to the threads. Slide a #8 screw through a washer and screw it into an anchor. 9 6 Repeat for the other anchor to secure the mounting plate to the wall. 6 Screw the anchors in the rest of the way with a Phillipshead screwdriver. 7 6 Repeat steps 5-6 for the other anchor.
PAGE 3
1G 1E DRIVER 11 10 12 10 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 11 Connect the white (blue) driver wire to the neutral power line wire with a wire nut. 12 Connect the black (brown) driver wire to the hot power line wire with a wire nut.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.