User guide

Installation Instructions for

Dia and Mini-Dia Pendant

980FSJDIA

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

Fusion Jack™

1.0

HS783_

SOCKET

LAMP

NOTE: Use only your fingers to install the lamp.

Push the lamp pins completely into the socket holes.

Use Type XelogenMAX 50 Watt

(Xenon) Bi-Pin Lamp.

CAUTION: RISK OF FIRE

Never replace a Xenon lamp with a regular Halogen lamp.

A Halogen lamp requires a protective glass shield.

Assemble the Fixture

Place the hardware inside the glass shade and install the

four mounting rods by screwing them in completely.

MOUNTING ROD

GLASS

SHADE

NOTE:To replace the lamp, reverse section 1.

HS782_

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

PAGE 1
Installation Instructions for 980FSJDIA HS782_ HS783_ Dia and Mini-Dia Pendant 1.0 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
Adjust the Fixture Height 2A 2E 6 ALLEN WRENCH SET SCREW CONICAL CONNECTOR 1 OUTER WRAPPED WIRE STOPS HERE Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench. 1 Feed and push the coaxial cable into the conical connector.The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector.
PAGE 3
2H 10 10 Firmly tighten the set screw on the conical connector. 2I 11 11 Pull the coaxial cable toward the fixture to smooth the wrinkles.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.