User's Manual

6

7. Mobile Phone Support
This IP camera can transmit live feed to your mobile phone, and support P2P for mobile monitoring, so that you can have
‘on the go’ access to your surveillance system from virtually anywhere. To view, you must install a mobile operating
system specific program into your mobile. The mobile programs are located on the included CD, or downloaded via “APP
Store” for an iPhone mobile, or downloaded via “Google Play” for an android mobile. In APP Store or Google Play, please
search for “MobileEyedoor+”. Please see the instruction manual for your mobile to install the program. Currently, there
are a limited number of phones that are supported: Google Android and Apple iPhone.
Note:
①. Prior to using this feature, you should apply for an Internet connection service for your mobile phone, such as
3G or 2.5G. Please contact your mobile service provider for details.
②. You can watch four live feed channels at a time with Google Android or iPhone Mobile.
③. It is recommended that in “mobile stream” section, the image quality of the IPC for remote access viewing via
mobile phone. The better the image quality is, the bigger the bit rate and the frame rate of the IPC are. Please
choose the suitable quality according to user’s bandwidth.
A. Soft AP function and wireless network
The ipcam can be worked in AP mode. If user doesn’t want to connect a wired cable to the indoor device, and user need
prepare a wireless router and a smart-phone or a pad with IOS or Android system.
Step 1. First user must install a mobile operating system specific program into his mobile or pad. and the iPhone and
android program should be downloaded via “APP Store” and “Play Store”. In “Play Store” or “APP Store”, please search
for “MobileEyeDoor+” and install it onto user’s mobile or Pad. Please see the instruction manual for user’s mobile to
install the program.
Step2. Turn on user’s phone WLAN function, then click the “MobileEyeDoor+” icon to run the program, click
“ + ” to select add mode, here must select “ Install & add new wireless device ” to the next interface to add
wireless device.

Step3. Then make the ipcam into standby mode, and long-press the “WIFI/ETH” button on the bottom panel, don’t loosen
the button until the blue light started flashing , this means the device will reboot automatically and go into AP mode.
Step4. On “WIFI setting” interface, wait for a moment and phone with android system can be connected to the device
WIFI successfully automatically. For the phone with IOS system user need to connect device WIFI function
manually. Click “Manual connect device WIFI ” to enter WLAN interface of user’s phone to see available networks,