User's Manual

3


C．The bottom and side interface
458









12367
1. EnterAPmodebutton
2. Thebottombracketinstallationposition
3. Microphone
4. Resetbutton，Pressthekeyequipmentwillrestorethefactorysettings
5. Cameralens
6. SDcardsocket
7. Speaker
8. IR

3. Device Connect
A．Thewiredmode
1). Connect the crystal head of network cable to RJ45 interface of IP camera.
2). Connect the power adapter to the electrical outlet of the IP camera and power on.
3). The network connection normally in 5 seconds at the network connection of light (orange) will light up, data indicator
light (green) shine, this time the network cameras physical connections to complete.
B. Wirelesss mode
1). Connect the power adapter to the electrical outlet of the IP camera and power on.
2). With the mobile phone will establish a connection between IPcam and wireless router。（Please refer to 7 “mobile
phone support” ）
4. Network connection and port forwarding
A. Network connection diagram as below:
