User's Manual

6
7. Soft AP function and wireless network
The ipcam can be worked in AP mode. If user doesn’t want to connect a wired cable to the indoor device, and user need
prepare a wireless router and a smart-phone or a pad with IOS or Android system.
Step 1. First user must install a mobile operating system specific program into his mobile or pad. and the iPhone and
android program should be downloaded via “APP Store” and “Play Store”. In “Play Store” or “APP Store”, please search
for “MobileEyeDoor+” and install it onto user’s mobile or Pad. Please see the instruction manual for user’s mobile to
install the program.
Step2. Turn on user’s phone WLAN function, then click the “MobileEyeDoor+” icon to run the program, click
“ + ” to select add mode, here must select “ Install & add new wireless device ” to the next interface to add
wireless device.
Step3. Then make the ipcam into standby mode, and long-press the “WIFI/ETH” button on the bottom panel, don’t loosen
the button until the blue light started flashing , this means the device will reboot automatically and go into AP mode.
Step4. On “WIFI setting” interface, wait for a moment and phone with android system can be connected to the device
WIFI successfully automatically. For the phone with IOS system user need to connect device WIFI function
manually. Click “Manual connect device WIFI ” to enter WLAN interface of user’s phone to see available networks,
and UID number of the ipcam device(the UID is attached to the machine) will be shown on the available networks
list. Select it and connected successfully means the mobile will be connected to the ipcam unit directly (shown as
follows).
Step5. Return to the “WIFI setting” interface and go to the next step. On this interface, available wireless devices will
be shown on the list. Choose one and click it, if the wireless password of the wireless router is enabled, it will
pop-up a window to enter the password of the wireless router, input the correct password and setting ok, the
ipcam device will reboot automatically, it will be connected to the wireless router after starting
Step6. Click “Next Step” to add ipcam device, input the correct password of the device, default as “888888", and then
save.
Step7. Return to the WLAN settings on the mobile and choose the wireless router which the ipcam has been
connected to. Now the wireless function of the ipcam device has been activation and works normally (Shown as
follows).
Step8. Now user can surveillance, communication, capture and recording on his phone/pad about the remote device via
the program “MobileEyeDoor+”
In the following diagram, we use a smart-phone with android system to a ipcam. The usage of an iPhone/iPad with
IOS system is similar.