User's Manual

1.7 Operation Introduction On Indoor Unit
VISITOR CALL
The Visitor press
the call button on
outdoor camera 1
A 10s of continuous
Ding Dong tone is heard
inside and outside
The visitor’s image
automatically displayed on
the screen(For the visual
indoor unit)
release the
door lock
Standby mode
Press the unlock
button on indoor
monitor
Press the Hang up button
on indoor monitor again
End
The Visitor press
the call button on
outdoor camera 2
If both call button on two outdoor camera are pressed at approximate
to the same time, the preference will be given to the outdoor camera
which call button was pressed first, unless the call button is pressed
again after the indoor monitor go into standby mode, please be aware
of that there is no indication on second outdoor camera but third
brief of tone will be heard on indoor monitor.
NOTICE:
Both the visitor’s voice and image will be not switched off within 20s of time span
when the unlock button is pressed, this individualized function allow you to make
sure whether the visitor already come in.
Start conversation
with outdoor camera
Press the Talk
button
The indoor unit will automatically go into standby mode if you are not
at home or have not reached the indoor unit in 60s.
The conversation
duration is 120s
at a time
Stop ringing
NOTICE:
Please be aware of Connection of 2 outdoor cameras is required.
◆
If the camera of outdoor unit is
masked, and can’t see the image.
Press this button to watch the image
from camera. Press it again to back
to the image of outdoor
unit.--
For the visual indoor unit
13
14
Talk
If a conversation with outdoor unit is underway in monitoring mode,
press the call button on either of outdoor unit, the monitoring mode will be switched off. the
just visitor’s image will appear on its screen and continuous ringing will be heard. You can
press the talk button to reactivate conversation with the visitor; for more detailed operations,
please refer to VISITOR CALL on page 13.
during this time a visitor
MONITORING On Indoor Unit(For the visual indoor machine)
Press the monitoring
button on indoor
monitor
Standby mode
Press the Talk
button
End
Press the monitoring
button on indoor
monitor again
Display image from 2nd
outdoor camera on the
screen.
Press the Hang up
button
Monitoring duration
is up to 60s at a time
Press the unlock
button to release
the door lock
Please note that if you are using two outdoor cameras, but it appears a blank when
you are activating the monitoring mode on either of indoor units, to completely solve this
accident, please pull out all power supply of indoor unit and then plug in power supply back
after 10s later.
display
Display image from 1st
outdoor camera on the
screen.
Start conversation
with outdoor camera
For a non-visual indoor unit, you can’t view the image of the outdoor camera on the
indoor unit, and you can view the image of the outdoor camera via web browser on PC or a
smart-phone/Pad with a specific program “MobileEyeDoor+”.
Press this button once
more to return to
standby mode
NOTICE:
If you are using only one outdoor camera in monitoring mode, you can also end the
monitoring mode by pressing the hang up button.
Please be aware of Connection of 2 outdoor cameras to 1 indoor monitor is required for d
entrance monitoring at least.
ual
◆
Talk
Hang up
For the models with SD card, if the SD card has been inserted into the indoor unit,
when visitor press the Call button on outdoor camera, the device will start recording
and the recording will continue to be a few seconds.