User Guide

Quick Reference
Guide
10X Control Panel & Wireless Remote
Quick Reference Guide
2 of 2
(*
regardless of Do Not Disturb On or Off)
Slide Do Not Disturb button to the RIGHT = ON for BLOCK the REMOTE
Slide Do Not Disturb button to the LEFT = OFF for UNBLOCK the REMOTE
©
©
Press the Find Me button and release* = LOCATE the REMOTE
©
Cradle:
USB Charging Port:
Plug the USB cable of a small portable electronic device into the USB charging port.
For Automatic Adjustment –
Use the Memory or Home Buttons
For Manual Adjustment –
Use the Remote Buttons
USB port
Home
Memory I
Memory II
Do Not Disturb
Find Me
Headrest
Home
Memory I
Memory II
Back
Legrest
Do Not Disturb (DND):
1. Turning on this feature blocks the furniture’s communication with
the remote.
2. Only the commands on the cradle are allowed when Do Not Disturb
is on—these commands are Memory I, Memory II, Home and Find
Me. The cradle commands are always active.
DND set to Block (On): Turning on DND while the furniture is in motion
from a Memory or Home button press on the remote, stops all motion.
The furniture’s communication with the remote is immediately blocked
when DND turned on. If the Memory or Home drive was started by a
cradle button press, the motion continues—DND has no affect on the
cradle commands.
Find Me: Always enabled, even when Do Not Disturb ON.
Locate a misplaced or lost remote with the help of this feature.
1. Press and release the Find Me button and a signal is transmitted to
the remote. Press and release it a 2
nd
time within 2 minutes of the
1
st
press to clear the Find Me mode.
2. LED lights flash and a loud tone plays from the remote when the
signal is received. (And 3 working AAA batteries installed in remote.)
This continues for 2 minutes OR until a button is pressed on the
remote OR a 2
nd
Find Me cradle button press within 2 minutes of 1
st
.
NO movement is produced by a remote button press when in Find
Me mode; a button press ONLY clears the Find Me mode.
USB Charging Port:
USB port charges small portable electronic devices. The USB port is for
charging only and does not save or transfer data. Port is off when system
reads < 22 volts, e.g. system operating on (2) 9-volt batteries or when the
system experiences an over-current (operating capacity exceeded).
Lumbar
Wireless Remote