User Guide

ManualsBrandsLAZYBOY ManualsremoteLAZYBOY Wireless Remote Control

Quick Reference

Guide

10X Control Panel & Wireless Remote

Quick Reference Guide

1 of 2

Press LEFT side of button (arrow UP /

) and hold = RECLINE/ EXTEND

Press RIGHT side of button (arrow DOWN /

–

) and hold = UPRIGHT/ RETRACT

Remote:

Press a Memory button and release* = Move to STORED SETTING

Press the Home button and release

Move to retracted and CLOSED POSITION

Remote or Cradle:

(Requires (3) AAA Alkaline Batteries; included.)

For Automatic Adjustment –

Use the Memory or Home Buttons

For Manual Adjustment –

Use the Remote Buttons

USB port

Home

Memory I

Memory II

Do Not Disturb

Find Me

Headrest

Home

Memory I

Memory II

Back

Lumbar

Legrest

Programming Memory I or Memory II: (not available on 9V battery backup)

1. Press and hold the Memory I or Memory II button for three (or more)

seconds on either the remote or cradle when in the desired recline

position.

2. Listen for the “beep” and watch for the LED lights to ﬂash to indicate

the setting was saved in memory.

• Memory I plays a single beep and LED ﬂashes once when the

save is successful

• Memory II plays a double beep and LED ﬂashes twice when the

save is successful

• Three quick beeps and ﬂashes of LED lights indicate an

unsuccessful save.

Unless intended, DO NOT press any button on the remote or cradle while

the furniture is in motion using Memory I or Memory II. Doing so interrupts

the program and stops the furniture from moving. Another press of the

Memory button is required to start the furniture in motion again.

Home Button:

The Home button returns the back is to its fully upright position and the

legrest, headrest and lumbar to the fully retracted and closed position.

1. Press and release the Home button to return the furniture to the upright

and retracted position.

Unless intended, DO NOT press any button on the remote or cradle while

the furniture is in motion using Home. Doing so interrupts the program

and stops the furniture from moving.

Another press of the Home button

is required to start the furniture in motion again.

Memory & Home Features

(automatic drive):

Start the automatic Memory and Home drive features from either a remote

OR cradle button press. Another button press on either the remote or

cradle stops the furniture from moving. Motion does not resume when

the button is released.

Wireless Remote

(*pressing and holding stores the setting)

Summary of content (2 pages)

PAGE 1
Quick Reference Guide 10X Control Panel & Wireless Remote Quick Reference Guide Wireless Remote Programming Memory I or Memory II: (not available on 9V battery backup) Home 1. Press and hold the Memory I or Memory II button for three (or more) seconds on either the remote or cradle when in the desired recline position. Home Memory I Memory II 2. Listen for the “beep” and watch for the LED lights to flash to indicate the setting was saved in memory.
PAGE 2
Quick Reference Guide 10X Control Panel & Wireless Remote Quick Reference Guide Wireless Remote Do Not Disturb (DND): Home 1. Turning on this feature blocks the furniture’s communication with the remote. 2. Only the commands on the cradle are allowed when Do Not Disturb is on—these commands are Memory I, Memory II, Home and Find Me. The cradle commands are always active.