Use and Care Manual
22
TROUBLESHOOTING
Problem Possible Cause Solution
Carriage bolts not seated properly.
Cam locks not tightened.
Adjust the height of the handle
and make sure the carriage bolts
are seated properly.
Tighten cam locks.
Tripped circuit breaker in the house.
Reconnect the cord and use the
cord retainer to keep the cord
close to the motor/blade control.
receptacle.
Reset house circuit breaker.
electrician.
replaced by an authorized
service center.
height not set properly.
the same cutting height for the
Handle not in position.
unevenly.
Wet grass clippings sticking to the
underside of the deck.
Wait until the grass dries before
properly.
and blade dragging in heavy grass,
Raise cutting height.
Blade is unbalanced.
Bent motor shaft.
Balance the blade by grinding
Stop the motor, disconnect the
damage. Have repaired made by
an authorized service center
before restarting.
higher speed