Replacement Part List

See Figure 5.
 Attach the outlet end of an extension cord to the plug on the rear of the blower.
 Route the extension cord through the side of the loop located on the rear of the blower housing and place
underneath the cord retainer.
 To start the blower, place the power switch in the
ON position.
 To stop the blower, place the power switch in the
OFF position.
 To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center
of a pile.
 To reduce sound levels, limit the number of pieces of equipment used at any one time.
 Use rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen surfaces when water
is available.

Watch out for children, pets, open windows, or freshly washed cars, and blow debris safely away.
NOTE: Use only an approved outdoor extension cord as described previously in this manual.
OPERATING THE BLOWER
 Hold the blower with the handle in your right hand. (Proper operating position is shown in figure 5.)
 Operate power equipment at reasonable hours only — not early in the morning or late at night when people
might be disturbed. Comply with the times listed in local ordinances.
 After using blowers or other equipment, CLEAN UP! Dispose of debris properly.
Fig. 5
OPERATION
10