Assembly Instructions

User Manual of Network Camera
76
B->A: Only the object crossing the configured line from the B side to the A side can
be detected.
4. Set the sensitivity [1~100].
5. Choose another line crossing on the dropdown list to configure. Up to 4 line
crossing areas are configurable.
6. Click Save to save the settings.
6.6.7 Configuring Intrusion Detection
Intrusion detection can set an area in the surveillance scene and once the area is
been entered, a set of alarm action is triggered.
Steps:
1. Check the Enable Intrusion Detection checkbox.
2. Click Draw Area, and then draw a rectangle on the image as a defense region.
Note: when you draw the rectangle, all lines should connect end to end to
each other. Up to four areas are supported.
Figure 6-50 Configuring Intrusion Area
You can click Clear to clear the areas you drawn.