Assembly Instructions

User Manual of Network Camera

3. Click Edit to set the arming schedule for the alarm input. Refer to Task 2 Set the

Arming Schedule for Motion Detection in Section 6.6.1.

4. Check the checkbox to select the linkage method taken for the alarm input. Refer

to Task 3 Set the Alarm Actions for Motion Detection in Section 6.6.1.

5. You can also choose the PTZ linking for the alarm input if your camera is installed

with a pan/tilt unit. Check the relative checkbox and select the No. to enable

Preset Calling, Patrol Calling or Pattern Calling.

6. You can copy your settings to other alarm inputs.

7. Click Save to save the settings.

6.6.4 Configuring Alarm Output

Steps:

1. Enter the Alarm Output Settings interface:

Configuration>Advanced Configuration> Events > Alarm Output

2. Select one alarm output channel in the Alarm Output drop-down list. You can

also set a name for the alarm output (optional).

3. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or

Manual. The delay time refers to the time duration that the alarm output remains in

effect after alarm occurs.

4. Click Edit to enter the Edit Schedule Time interface. The time schedule

configuration is the same as the settings of the arming schedule for motion detection

Refer to Task 2 Set the Arming Schedule for Motion Detection in Section 6.6.1.

5. You can copy the settings to other alarm outputs.

6. Click Save to save the settings.