Assembly Instructions

User Manual of Network Camera

WPS (Wi-Fi Protected Setup) refers to the easy configuration of the encrypted

connection between the device and the wireless router. The WPS makes it easy to

add new devices to an existing network without entering long passphrases. There are

two modes of the WPS connection, the PBC mode and the PIN mode.

Note: If you enable the WPS function, you do not need to configure the parameters

such as the encryption type and you don’t need to know the key of the wireless

connection.

Steps:

Figure 4-10 Wi-Fi Settings - WPS

PBC Mode:

PBC refers to the Push-Button-Configuration, in which the user simply has to push a

button, either an actual or virtual one (as the button on the

configuration interface of the IE browser), on both the Access Point (and a registrar

of the network) and the new wireless client device.

1. Check the checkbox of to enable WPS.

2. Choose the connection mode as PBC.

Note: Support of this mode is mandatory for both the Access Points and the

connecting devices.

3. Check on the Wi-Fi router to see if there is a WPS button. If yes push the button

and you can see the indicator near the button start flashing, which means the WPS

function of the router is enabled. For detailed operation, please see the user guide of