Instructions / Assembly

Remote Control
A. Press the On/Off switch to activate the heater
B. To operate the heater on low power (700W), press on the left side button of the remote control
C. To operate the heater on medial (800W), press on the right side button of the remote control
D. Press on both the left and right side button of the remote control for maximum power (1500W)
E. To operate the LED light, press the top button
of the remote control
Operation of Operation of Touch Switch
• Press the On/Off switch to activate the heater
• Touch the touch switch once to operate the heater on 700W power.
• Touch the touch switch twice to operate the heater on 1500W power.
• Touch the touch switch third times to activate the LED light without heat.
• Touch the touch switch four times to operate the LED light and to operate the heater on 1500W power.
• Touch the to
uch switch five times to shut off the light and heat.
Care and Maintenance
• When disconnected from the electrical supply, clean the surface of the patio heater
with a damp cloth. Never use corrosive or solvent cleaners or immerse in water.
• Any maintenance or repairs including replacing the halogen tube should only be
carried out by a qualified electrician or by a recommended service center.
Technical Specifications
• Power supply 120V 60Hz • Wattage max 1500W
• Insulation class I • Width10cm; Length 59,5cm
Grounding Instructions
This heater is for use on 120 volts.
The cord has a plug as shown at A in
Figure 60.1. An adapter as shown at
C is available for connecting three-
blade grounding-type plugs to two-
slot
slot receptacles. The grounding plug
extending from the adapter must be
connected to a permanent ground
such as a properly grounded outlet
box. The adapter should not be used
if a three-slot grounded receptacle
is available.