Instructions / Assembly

10
ASSEMBLY INSTRUCTIONS
Hardware Used
DD
PP
9
10
9. Install 2pcs side panels (I) with 8pcs
M5x12 screws.
Note : Do not cover the front panel where the
control knob is located.
10. Assemble the chain (MM) and wafer (LL)
to the inside of front panel (N) with M4x10
screw (NN) and M4 nut (KK) and then install
the knob (JJ) to M4x10 screw. Hang the chain
to the hole on the control box assembly and
attach the pothook on front panel to the holes
of bottom plate.
x 8
Philips
screwdriver
Screw M5 X 12
x 1
I
MM
JJ
N
Hardware Used
NN
PP
x 1
x 1
x 1
x 1
x 1
Philips
screwdriver
Screw M4 X 10
x 1
LL
MM
wafer
Chain
JJ
KK
Nut M4
Knob
11
ASSEMBLY INSTRUCTIONS
11
12
11. Install the protective guard (E).
Hang the 3pcs protective guards on upper
supports, fix them with 3pcs M5x12 screws
and 3pcs fixing brackets (GG).
12. Install the reflector (A) with 3pcs studs
(CC), lean the heater carefully and attach
the 3pcs small flat washer Φ8 (BB) on top
of the heater. Put washer on each stud and
fasten the reflector with another washer and
wing nut (AA). Return the heater carefully to
upright position.
Hardware Used
AA
BB
x 3
x 6
Small flat
washer Φ8
Wing nut
Hardware Used
DD
GG
x 3
x 3
x 1
Fixing Bracket
PP
Philips
screwdriver
Screw M5 X 12
E
A
AA
CC
BB
GG
CC
x 3
Stud