Lava RS422-550 Installation Manual MADE IN SERIAL 2 CANADA SERIAL 1 LAVA RS-422 LAVA COMPUTERS Rev. B00 P.N. MOKO L26.
Hardware Set-Up Serial 2 Settings 16C552 IRQ Settings Serial 2 Serial 1 Settings Serial 1 COM Address Configuration Serial Settings COM 1 (03F8h)* Default for Serial1 COM 3 (03E8h) COM 5 (02D8h) COM 2 (02F8h)** Default for Serial2 COM 4 (02E8h) COM 6 (02C8h) Serial IRQ Settings Serial 2 Serial 1 15 12 11 10 7 5 2 2 4 3
RS-422 Configuration Serial Configuration 1. Determine the number of serial ports installed in your system. Each serial port will have an unique "COM" designation. Configure the ports of the RS422-550 for two unused COM addresses. 2. Determine which IRQs (interrupts) are free in your system. Configure each serial port on the RS422-550 for an unused IRQ. Although some devices allow sharing of IRQs, this is not recommended.
. For Windows users: After you have configured the RS422-550 jumpers, you will need to go through the “Add New Hardware” procedure in Windows Control Panel. Install the two ports on the RS422-550 as Standard Communications Ports when prompted.
Lava Technical Support 9:00 am to 5:30 pm Monday to Friday (Eastern Time) Tel: +416 674-5942 Fax: + 416 674-8262 E-mail: tech@lavalink.com Internet: www.lavalink.com Lava Computer MFG Inc. This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Lava Computer MFG Inc. 908 Niagara Falls Blvd.
