1. Recommended Tools FIGURE 1 3, Parts Breakdown (Model Numbers Ending in TRAMCAR) V/ Sy LIMIT STIR Adjustable Wrench Allen Wrench (3mm) Orly Phillips Screwdriver Safely Glasses Thread Seat Tape 2 | Flow Control Spindle IO 2. Dimensions IMPORTANT: Model numbers ending in TRAMCAR coordinate with Tremolo pressure balancing valve: no We B A portulaca with Test Cap. The Test Cap Is used fo N allow pressurization of system.
. installation Slide Bar Assembly 1 Remove slide bar ends farm slide bar flanges. Using flanges a5 3 guide, drill /8" plat hots into studs ar woad blocking, With side bar in position, secure to wal using screws. Attach side bar ends to bar flanges FIGURE 1. 2) Remove screw cap from skids mechanism (FIGURE 11.2), 3 Remove wand holder from slide mechanism FIGURE 113, 4) Remove lever handle from side mechanism FIGURE N.4). 53 Install slide mechanism components ta skids bar following STEPS ravers.
) Copper, IPS, PVC, PEX (Crimp) & PEX ¢ G L XV-3247 REV FIGURE 2.2 Rapid instail™* Bracket is used to secure valve Between wall studs up to 24 Inches, center to center, Bracket will fit in minimum 2x3 wall cavity, Bracket will rough valve at from center fine of valve ports to front of finished wall, 1. Place metal straps (x4) over screws. Screws will come reassembled to bracket. 2. Pull metal straps tight against bracket SARS, Screws will protrude through small screw hole in metal straps. 3.
4. DETERMINE W/ 4.1 Protective Shield G 4.2 Valve Mounting Plate FIGURE FIGURE 4.2 & Without service stops With service stops 4.3 Drywall or Other Type Wall FIGURE 4.3 shower supply Routine me), peeve centering o front of Finished veal hot & contd supply inlays tub spout supply V2413 ) or greater scrotal st | Wall Cutout Hole Sv;gj 2-1/2 (89 mmy min " (102 tem) max Finished wall 4.4 Thin Wall Installation FIGURE 4.
6. BACK TO BACK INSTALLATION 6.1 Back to Back Wall Type FIGURE 6 2-3/8 MIN, WALL THICKNESS /2" €140 men) g cop 6.2 Identify Reverse Seat Valve MODEL NUMBERS: 26280DY 262XBODY REVERSE SEAT VALVE, SHOWER PORT FIGURE 8.5 STANDARD VALVE Z-3247 REV o simplicity piping on back to back installations, use one standard valve (hot on left, cold on right) and one SureGrip™ reverse seat valve (hot on right, cold on left) as shown in FIGURE 6.
. SERVICE INSTRUCTIONS 9.1 Removing Flow Control Spindle Reference parts breakdown (see FIGURE 101, See trim manual for tim removal instructions, Shut off water supply to valve, Turn TA-IO flow control spindle to open position using tors hand. i Remove trim handle and dome cover, : Remove escutcheon plate by First removing escutcheon screws. . Unscrew both T-12A cap assembly and flow control spindle together. 9.
Le]V]: PROBLEM Valve leaks when shut off, Valve definers sufficient quantity of cold, but tittle hot, or the reverse. Valve delivery temperature reduces gradually during use: fade must be turned to fitter positions to maintain constant temperature. Hot and cold washers are worn or foreign matter (dirt, chips) is Lodged between washers and seat surfaces. Same as above. Overdraw on hot water supply (i.e. running out of hot water). SOLUTION Replace washers using TA-S washer repair kit. .
