Installation Guide

laurelmountainbath.com • 800.930.0050
— 5 —
Installation Instructions
Shower Stalls and Tub-Showers (Sectional Units)
GRAB BAR INSTALLATION
The grab bars are fastened to the shower wall using the provided screws. Review these
instructions before you begin installation.
1. Determine the location you want to install the grab bar. Place the grab bar in the
desired location and mark the location of each mounting hole for both ends of the
grab bar.
2. Using a
1
⁄8” drill it, drill each mounting hole at a depth of 1”.
3. Apply silicone caulking around each mounting hole before installing the grab bar.
4. Start mounting by hand, one screw in each end of the bar.
5. Use a power drill with a Phillips head bit to fully install mounting screws.
6. Install the remaining mounting screws into the mounting holes. Snug the screws but
do not overtighten.
CURTAIN ROD INSTALLATION
The curtain rod is fastened to the shower wall using the provided rod cups, screws, and
lock nuts.
1. Determine the location of the curtain rod/rod cups.
2. Carefully measure and mark the mounting hole locations for the rod cups.
3. Drill pilot holes that are slightly smaller than the mounting screws.
4. Fasten the rod cups to the wall by tightening the mounting screws.
5. The curtain rod can now be cut to fit the unit. Measure the inside of the unit right
above the threshold.
6. Once the measurement is determined you will subtract
3
⁄4” off the total measurement.
7. Cut the curtain rod and snap each end into the rod cups.
Laurel Mountain
26 Nesbitt Rd., Suite 257
New Castle, PA 16105
[e-mail]