Installation Guide

1of1
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
(3)A19MediumBase100WbulbMaximum,bulbnotincluded.
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.MissingParts?Contactyouroriginalplaceof
purchase.
LightSource:
EstimatedAssembly Time:
Preparation:
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 2 - Wire Connections
A.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Package Contents
B
Lock Screw
x2
A
Shade
x3
E
Fixture
Body
x1
C
D
Lock Screw
x9
Crossbar
x1
STEP 1 Install the Crossbar to the junction box-
.
A. Attach the Crossbar (A) to the Outlet Box with the head of the Green
Ground Screw facing you. Secure it with Outlet Box Screws (not
included), tighten until snug
STEP 3 Install Fixture Body-
A. Place the Backplate and the
Fixture Body (D) over the
Crossbar (A). Line up Holes on
the side of backplate and the
Mounting Hole on the Crossbar
(A). Secure by threading Lock
Screws (B) into the Crossbar (A).
Tighten until sung.
FINISH: EARTH BLACK
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4"
Figure 1
Outlet Box Screw
(not supplied)
A
Supply Wires and
Ground Wire
Outlet Box
D
Figure 3
B
A
Outlet Box
STEP 4 - Install Shade and Bulb
A. Place the Shade (E) over the socket
and align the holes on the Shade (E)
to mounting holes on tabs. Secure
by threading Lock Screws (C) into
tabs and extruding from holes on the
Shade (E). Hand tighten until snug
to engage the Shade (E).
B. Insert bulb onto socket and screw
snugly into place.
Your fixture is now assembled and
ready to use. Enjoy!
T10 Vintage Bulb
(recommended
but not supplied)
E
D
C
Socket
Tab
4.5”
5” Dia.
6.5”
9.75”
7.25”
8”
24”
5.25”
Installation Guide