Assembly Instruction
Package Contents
1of2
C
B
Mounting Screw
x2
Inner
Backplate
x1
A
Shade
x3
D
Fixture Body
x1
E
Figure 1
Outlet Box Screw
(not supplied)
D
STEP 4 - Install Shade and Bulb
A. Place the Shade (E) over the socket
and align the holes on the Shade (E)
to mounting holes on tabs. Secure
by threading Lock Screws (C) into
tabs and extruding from holes on the
Shade (E). Hand tighten until snug
to engage the Shade (E).
B. Insert bulb onto socket and screw
snugly into place.
Your fixture is now assembled and
ready to use. Enjoy!
STEP 3 - Install Fixture Body
A. Attach the Fixture Body (D) over the Inner Backplate (A) and secure
with Mounting Screws (B). Tighten until snug with screwdrivers.
Lock Screw
x9
Figure 3
(3)A19MediumBaseBulbs100WMaximumor
(3)T10MediumBaseVintage Bulbs are recommended but not supplied.
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
LightSource:
EstimatedAssembly Time:
Preparation:
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
STEP 1 Installing the Inner Backplate-
A. Pass the supply wires and ground wire through the Inner Backplate
(A). Attach the Inner Backplate (A) to Outlet Box with the head of
Green Ground Screw facing you. Secure it with Outlet Box Screws
(not included). Tighten until snug.
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 2
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from fixture
Bare, or Green
Ground wire
from outlet box
OR
Ground wire
from fixture
Green Ground Screw
on the Crossbar
B
A
Outlet Box
A
Figure 4
T10 Vintage Bulb
(recommended
but not supplied)
E
D
C
Socket
Tab
A
Supply Wires and
Ground Wire
Outlet Box
Assembly Instruction