Installation & Assembly

ManualsBrandsLaurel Foundry Modern Farmhouse ManualsLightingBraydon Outdoor Barn Light

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Thread two fixture mounting screws through the cross bar, and then secure them with four lock nuts. Adjust the length

of the fixture mounting screws if necessary.

Note: Make sure that the fixture mounting screws are lined up horizontally to make the fixture level.

2. Attach the cross bar to the outlet box by using two mounting screws.

3. Pull out the source wires from the outlet box. Make wire connections using wire Connectors as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the cross bar with the green

grounding screw, and then connect it to the house grounding wire with the wire Connector

Carefully put the wires back into the outlet box.

4. Attach the fixture to the cross bar by inserting fixture mounting screws into holes on back plate, and then secure it

with two rubber pads and two ball nuts.

NOTE:With silicone caulking compound, caulk completely around where the back plate meets with the

wall surface to prevent water from seeping into the outlet box.

Green Grounding Screw (C)

Outlet Box

Wire Connector (F)

Fixture Mounting Screw (D)

Cross Bar (A)

Lock Nut

(E)

House Grounding Wire

Fixture Grounding Wire

Fixture Wire

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

Bulb Type A Max.60W

(not included)

Ball Nut(G)

Rubber Pad(H)

Fixture

Holder

Socket

Socket Ring

Shade

Photocell

Back Plate

Turn off the power at fuse or circuit box.

Installation Steps

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

Mounting Screw (B)

Lock Nut (E)

Mounting Screw (B)

Wire Connector (F)

Ball Nut (G) Rubber Pad (H)

Cross Bar (A)

Hardware Package (included):

Fixture Mounting

Screw (D)

Green Grounding

Screw (C)

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Attach the shade to the holder, and then secure it with the socket ring. 6. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage. Turn on the power at fuse or circuit box. Operation the Unit Without Photocell Photocell Black Wires From Photocell White Wires From Photocell Red Wires From Photocell Wires From Fixture Wires From Main Power Wire Connector Pigtail Wire Connector White Pigtail Wires From Fixture Fig.1 Fig.2 1.