Assembly And Installation Instructions

ManualsBrandsLaurel Foundry Modern Farmhouse ManualsBathroom Vanity LightingLeonie 4-Light Vanity Light

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

Green Grounding

Screw (C)

Headless Screw(D)

Mounting Screw (B)

Wire Nut (E)

Installation Steps

1. Thread two headless screws through the mounting plate, and then

secure them with four lock nuts (two on each side of the mounting

plate). Adjust the length of the headless screws if necessary.

Note: Make sure that the headless screws are lined up perpendicularly

to make the fixture level.

2. Attach the mounting plate to the outlet box by using two mounting screws.

3. Pull out the source wires from the outlet box. Make wire connections using

wire nuts as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black

wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the

white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to

the mounting plate with the green grounding screw, and then connect it to

the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

Mounting Plate (A)

Ball Nut (F)

Lock Nut (G)

Socket Fixer

Glass Shade

Ball Nut (F)

Socket

Spacer

Socket Ring

Bulb Type A Max.100W

(not included)

Back Plate

Glass Holder

Mounting Screw (B)

Mounting Plate (A)

Wire Nut (E)

Headless Screw(D)

Lock Nut(G)

Outlet Box

Fixture Wire

Green Grounding Screw (C)

House Grounding Wire

Fixture Grounding Wire

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Attach the back plate to the mounting plate by inserting two headless screws, and then secure it with two ball nuts. 5. Attach the glass shades to the glass holders, and then secure them with spacers and socket rings by using supplied socket fixer. 6. Install bulbs(not included). Check relamping label at socket area or packaging for maximum allowed wattage. Turn on the power at fuse or circuit box The following parts are available for re-order if damaged or missing.