Instructions / Assembly

Assembly instruction

Please read these instructions carefully before starting assembly. We suggest you carry out the assembly on

a soft surface like a carpet, so as to avoid scratching the paint. Please note because of the nature of cast

metal, you may find roughness on the surface which enhances the beauty of the product and is not a defect.

*Do not discard any of packaging until you have checked that you have all parts and pack of fittings.

*Keep children away during assembly.This item contains small parts which can be swallowed by children.

*Retain the assembly instructions for future reference.

ltem Photo Description Qty ltem Photo Description Qty

A Backrest Panel 1 F Bolts (8*25mm ) 4

B Chair Seat Panel 1 G Washers ( 8mm ) 4

C Right arm 1 H

Springs Washers

( 8mm)

D Left arm 1 I Nuts ( 8mm ) 4

E Bolts (8*18mm ) 4 J Plastics cap 4

1. Place all parts on a clean soft surface.

2. Attach the backrest panel (A) and the chair seat panel (B) to the right arm (C) and left arm (D) using

the bolts (E) and washer (G&H) for backrest panel and bolts (F) Washers(G), Spring washers(H) and

Nuts (8mm)(I) for seat panel like as follows:.

3.Then tighten the Nuts using the wrench . DO NOT over tighten .

4.Adjust the pre-installed Rubber Caps until the chair is level with the ground .

5.Tighten all screws and cover the Caps(J) on the nuts(I).Your Bench is ready for use now.