Instructions / Assembly

WARNING:

Proper assembly is the responsibility of the installer, a well-ventilated space and do not place in a building, Place heater in

or any other enclosed area. An appliance must installed with shelter no more inclusive than: 1.With walls on all sides,

no overhead cover.

2.Within a partial enclosure which includes an overhead cover and no more than two side walls. These side walls may be

parallel, as in a breezeway, or at right angles to each other. 3.Within a partial

enclosure which includes an overhead cover and

three side walls, as long as 30% or more of the horizontal periphery of the enclosure of permanently open.

but with

garage

STEP 1

1-1. Use 4 pcs M6x15mm Bolts

to fix the Tank Housing to the

Base & Cast Iron.

1-2. Tighten the Bolts as

shown above.

STEP 3

3-1. Fix the Regulator to the

Tank Housing with the

M5x10mm Bolt & M5 Nut.

STEP 2

2-1. Put the Burner on the Tank

Housing then fix them with

4 pcs 3/16” Bolts.

ASSEMBLY