Instructions / Assembly

CAUTION: Avoid inhaling fumes emitted form the heater’s first use.
Smoke and odor from the burning of oils used in manufacturing will
Appear .Both smoke and odor will dissipate after approximately
30minutes .The heater should NOT produce thick black smoke.
Note:
The burner may be noisy when initially turned on. To eliminate excessive
noise from the burner, turn the control knob to the “LOW” position, then
turn the knob to the level of heat desired.
When hear is ON:
Emitter screen will become bright red due to intense heat.
Burner will display tongues of blue flame.
These
f lames should NOT be yellow or produce thick black smoke. This indicates an
o bstruction of airflow through the burners
Operation Pressure Checked
If the flame is very small, this is because the supply pressure is not enough
to light.
1. Turn the control knob to “OFF” position.
2. Wait f ive minutes before attempting to relight pilot.
3. Repeat steps beginning with step 2 on page 9.
Before Leaving
1. Turn the control knob to “OFF” position.
2. Never leave the patio heater unattended while in use.
Shut down instructions
1. Push in and turn control knob c
lockwise to “O
2. Disconnect the LP cylinder when heater is no in use.
Note: after use, some discoloration of the emitter screen is normal
The event of gas leakage
1. Turn the control knob to “OFF” position
2. Wait 5 minutes to allow gas to dissipate
3. If odor continues, immediately call gas supplier
WARNING:
Heater will be hot after use; handle with extreme care.
10
OPERATION
FF” position.