Instructions / Assembly

Assembly Instruction
Please read these instructions carefully before starting assembly. We
suggest you carry out the assembly on a soft surface like a carpet, so as
to avoid scratching the paint. Keep children away during assembly. This
item contains small parts which can be swallowed by children.
function and is not to be used as a toy. This product is for residential
use only. This product is NOT intended for commercial use;
unintended use will void the warranty.
This product is not intended for use during inclement or severe weather,
that includes but is not limited to rain, hail, sleet, snow, wind, freezing
conditions and extreme heat.
Please note because of the nature of cast metal, you may find
roughness on the surface which enhances the beauty of the product and
is not a defect.
Aluminum is soft metal, please do not use power tools, and over tighten
may strip threads or break the parts.
Do not locate the product near any sort of high heat. Do not use the
product as a support. Do not shake or lean on the swivel chair.
supervised by a competent adult at all times.
assembly instructions for future reference or warranty.
1.Step 1: Place all the parts on a clean and soft surface, identify all the
parts and hardware kits against parts list;
2.Step 2: Assemble Seat(A) and Connector(B) first, and make sure the
direction of connector(B) is correct as Fig(1). This is very important for
safe. Install hardware parts(E D Y H F) in the order displayed in Fig(2).
Do not tighten the bolts and nuts before they are all set up;
3.Step 3: Tighten all the bolts and nuts with Wrench(U), then put on all
the Nut Caps(G). Do not over tighten bolts and nuts, it will cause the
damage of U bar of Seat(A) without warranty;
4.Step 4: Insert the installed rotating shaft into the Base(C) as Fig(3);
Your chair should be ready for use. If your chair is not rocking properly,
double check your assembly procedure, especially Step 3.
G
E
D
A
B
G
Seat Front
B
A
Y
H
C
F
B
Fig(2)
G
Fig(1)
Fig(3)
Item Photo
Description
Qty
Item
Photo Description
Qty
A
Seat
1
F
Nut
4
B
Connector
1
G
Nut caps
16
C
Base
1
H
Lock Washer
4
D
Washer
2
Y
Washer
4
E
bolts(8*35)
4
U
Wrench
1