Instructions / Assembly

Assembly Instructions
Please read these instructions carefully before starting assembly. We suggest you carry out the assembly on a soft surface like a carpet, so as to avoid scratching the paint.
Please note because of the nature of cast metal, you may find roughness on the surface which enhances the beauty of the product and is not a defect.
*Do not discard any of packaging until you have checked that you have all parts and pack of fittings.
*Keep children away during assembly.This item contains small parts which can be swallowed by children.
*Retain the assembly instructions for future reference.
List of Parts for Assembly of Garden Chair:
No. Parts Qty
A Backrest 2
B Chair Seat 2
C Chair Leg 8
D Flat Washer 20
E Spring Washer M8 20
F Nut 20
G Rubber Pad(Pre-installed) 8
H Wrench 1
FIG.3
H
J caps 20
Assembly Instructions
1.Place all parts on a clean soft
surface.
2.Align the two Studs on the
Backrest(A)with the holes in the Chair
Seat(B).
3.Attach the backrest(A) to the Studs on the
chair seat(B)using Washers and
Nuts(D.E.F),Tighten the Nuts using a wrench
(H). DO NOT over tighten(Fig.1)
4.Attach the back legs(C) to the Studs in
the Chair Seat(B) using Wahsers and
Nuts(D,E,F).Tighten the Nuts using
wrench(H) .DO NOT over tighten Repeat
this procedure for the front legs(Fig.2)
5.Adjust the pre-installed Rubber pads(G)until the
chair is level with the ground (Fig.3).Upon
completion of full assembly and bolted up all
screws can be tightened down. Put all caps(J) on
the nuts.
A
B
C
D
E
F
D
E
F
FIG.2
FIG.1
J