Instructions / Assembly

1.Step 1: Place all the parts on a clean and soft surface, identify all the parts and hardware
kits against parts list;
2.Step 2: Assemble Seat(A) and Connector(B) first, and make sure the direction of
connector(B) is correct as Fig(1). This is very important for safe. Install hardware parts(E D Y
H F) in the order displayed in Fig(2). Do not tighten the bolts and nuts before they are all
set up;
3.Step 3: Tighten all the bolts and nuts with Wrench(U), then put on all the Nut Caps(G). Do
not over tighten bolts and nuts, it will cause the damage of U bar of Seat(A) without
warranty;
4.Step 4: Insert the installed rotating shaft into the Base(C) as Fig(3);
Your chair should be ready for use. If your chair is not rocking properly, double check your
assembly procedure, especially Step 3..