Instructions / Assembly

1.Step 1: Place all the parts on a clean and soft surface, identify all the
parts and hardware kits against parts list;
2.Step 2: Assemble Seat(A) and Connector(B) first, and make sure the
direction of connector(B) is correct as Fig(1). This is very important for
safe. Install hardware parts(E D Y H F) in the order displayed in Fig(2).
Do not tighten the bolts and nuts before they are all set up;
3.Step 3: Tighten all the bolts and nuts with Wrench(U), then put on all
the Nut Caps(G). Do not over tighten bolts and nuts, it will cause the
damage of U bar of Seat(A) without warranty;
4.Step 4: Insert the installed rotating shaft into the Base(C) as Fig(3);
Your chair should be ready for use. If your chair is not rocking properly,
double check your assembly procedure, especially Step 3.