Installation Guide

The pedestal arrives with the feet tight against the bottom of the
unit. Using a 1/4" hex head ratchet or open-end wrench, lower
the feet approximately 1" away from the bottom of the pedestal.
Tip the washer/dryer back to its upright position. Remove
and discard any remaining packaging material.
COMPLETE THE INSTALLATION
Follow the installation instructions that came with your model
to nish installing or reinstalling your washer/dryer (i.e., hoses,
vents, etc.).
Place a level on top edges of washer/dryer, checking each side
and front. Rock machine back and forth to make sure all four
feet make solid contact with oor.
If not level, adjust pedestal feet up or down, repeating as
necessary.
Locate the 1/4" hex head screws on the top of each pedestal
foot. Reach inside the pedestal and use a 1/4" hex head ratchet
or open-end wrench to adjust the feet up or down as needed to
level the washer/dryer.
5
7. Stand the washer/dryer upright
9. Check levelness of washer/dryer
10. Adjust pedestal feet
Not Level
LEVEL
Not Level
Place level here
8. Move close to nal location
1"
(25 mm)
6. Prepare pedestal feet