Product Manual

TLT240SB Two-post User’
s Manual
12
M19×140 anchor bolts
1
0
8
m
m
(
4
.
2
5
i
n
)
10 sets
φ19mm
(φ0.75in)
Drill
Clean
1
0
8
m
m
(
4
.
2
5
i
n
)
Fasten
Expand
Concrete intensity should be above 3000PSI(2.1Kg/mm )
column
2
column
4000mm(157.5in)
Width 1800mm(70.9in)
Floor plate
Fig.11
Note ：
：：
：
♦ Use sharp Φ
ΦΦ
Φ 19mm concrete drill-bit to drill the
holes so as not to drill the hole too large. Use
proper pneumatic tool to remove the dust from
the hole. The depth of the hole is the same as that
of the anchor bolt. Insert the anchor bolt and
make the washers lean against the base of the
column.
♦ Only use torque wrench instead of impact tools to
fasten anchor bolts.
♦ Insert proper steel shim under the base seat of
column to plumb the column.
Note: The thickness of shims shouldn’t exceed
5mm.
To get the correct and safety installation, please follow
the following installation steps.
 Wear the safety goggles
 Use hard alloy drill-bit.
 Don’t use the drill-bit with wearing exceeding the
tolerance.
 The drill and concrete surface should be kept
perpendicular.
 Let the drill work itself. Don’t apply the extra force,
and don’t ream the hole or allow the drill to wobble.
 The drilling depth of hole is based on the length of
anchor bolt .The distance from the bolt head to the
concrete floor should be more than twice of the bolt
diameter.
 Remove the dust from the hole.
 Gently tap the bolt into the hole till the washer rests
against the base plate of column.
 Fasten bolts
10.2.4 Install the floor plate
Position the offside column at the designated chalk line
location, carefully making the base align with the chalk line
layout. Insert the floor plate into the U gaps of the base
seat of two columns.
Note:
 Since the offside column is not fixed to the ground,
you must operate carefully to avoid the falling of
the column.