Installation Guide
45 
TROUBLESHOOTING GUIDE 
PROBLEM  REASON  SOLUTION 
Power Unit (Motor) not 
running. 
Bad Fuse or Circuit breaker.  Replace bad fuse or reset circuit 
breaker.
Incorrect voltage to motor.  Provide proper voltage to motor. 
Improper wiring.  Have certified electrician check 
wiring. 
Power Unit up switch not 
functioning. 
Replace Power Unit up switch. 
Overhead Microswitch not 
functioning. 
Replace overhead Microswitch. 
Power Unit motor burned out.  Replace motor. 
Power Unit (Motor) runs but 
lift does not go up. 
Low oil level.  Fill reservoir with proper 
hydraulic oil. 
Lowering valve remains open.  Repair or replace oil valve. 
Pump sucking air.  Tighten all fittings and suction 
lines. 
Lift goes up slowly or oil 
coming out from filler cap. 
Air in hydraulic fluid lines  Bleed hydraulic lines (Call 
installer). 
Lift doesn’t come down.  Dirt in directional valve  Call installer to clean valve. (Do 
not attempt to open hydraulic 
lines unless vehicle is secure) 
Safety Locks do not engage.  Safety lock jammed.  Oil or replace pin to free Safety 
Lock. 
Check or replace spring. 
Safety Lock does 
not disengage. 
Safety lock is being limited  Check for any obstructions. 
Lift goes up unlevel.  Equalizing cables are loose.  Adjust equalizing cables to 
correct tension. 
Floor unlevel.  Shim lift to make towers level. 
(Do not exceed ½” of shimming). 
Lift goes up with chatter or 
does not fully rise. 
Low oil level.  Fill reservoir to correct level with 
proper hydraulic oil. 
Air in hydraulic fluid 
lines/cylinder. 
Bleed hydraulic lines. (Call 
installer). 
Anchor bolts do not stay tight.  Holes are too large.  Relocate lift using proper size 
drill bit. 
Incorrect concrete floor 
specification (Thickness and 
holding strength). 
Break existing floor and pour 
new pad for lift. 
Noticeable Deflection of Arm 
or arm dragging on floor. 
Lift out of plumb.  Plumb columns. 
Unlevel floor.  Replace floor of shim columns. 
Worn arm or carriage holes.  Replace parts. 
Worn carriage slide blocks.  Replace side blocks. 
Bent arm (Overloaded).  Replace arm. Also check 
damage to carriage. 










