Installation Guide
4 
13. Use only as described in this manual. Use only manufacturer’s 
recommended attachments. 
14. 
ALWAYS WEAR SAFETY GLASSES.
 Everyday eyeglasses only have 
impact resistant lenses, they are not safety glasses. 
15. Inspect lift daily. Do not operate if it malfunctions or problems have been 
encountered. 
16. Never attempt to overload the lift. The manufacturer’s rated capacity is 
shown on the identification label on the power side column. Do not 
override the operating controls or the warranty will be void. 
17. Before driving vehicle between the towers, position the arms to the drive- 
through position to ensure unobstructed clearance. Do not hit or run over 
arms as this could damage the lift and/or vehicle. 
18. Only trained and authorized personnel should operate the lift. Do not allow 
customers or bystanders to operate the lift or be in the lift area. 
19. Position the lift support pads to contact the vehicle manufacturers 
recommended lifting points. Raise the lift until the pads contact the 
vehicle. Check pads for secure contact with the vehicle. Check all arm 
restraints and insure they are properly engaged. Raise the lift to the 
desired working height. 
20. Some pickup trucks may require an optional truck adapter to clear running 
boards or other accessories. 
21. 
NOTE:
 Always use all 4 arms to raise and support vehicle. 
22. 
Caution!
 Never work under the lift unless the mechanical safety locks are 
engaged. 
23. Note that the removal or installation of some vehicle parts may cause a 
critical load shift in the center of gravity and may cause the vehicle to 
become unstable. Refer to the vehicle manufacturer’s service manual for 
recommended procedures. 
24. Always keep the lift area free of obstruction and debris. Grease and oil 
spills should always be cleaned up immediately. 
25. Never raise vehicle with passengers inside. 
26. Before lowering check area for any obstructions. 
27. Before removing the vehicle from the lift area, position the arms to the 
drive-thru position to prevent damage to the lift and /or vehicle.










