Installation Guide

INSTALLING THE PADDED SAFETY BAR AND SHUTOFF SWITCH

Install the safety shut-off electrical switch to the bracket on the underside of the overhead

beam adjacent to the power unit column. Use the provided shoulder bolt and cotter pin to

attach to the bracket and then route the electrical cord up into the overhead beam via the

small hole next to the bracket. When this is done the shut-off switch will be in a vertical

position. When the shut-off bar is installed shut off bar will protrude into the open end of the

safety switch as shown in the photo below.

After inserting the rounded end of the shut off bar into the electrical switch (as shown

above) connect the flatted end of the padded shut off bar to the underside of the

overhead beam adjacent to the slave side column using the provided should bolt and

nut. See photo below for reference.

Note: The Electrical Shutoff Switch cord will be connected when the power unit is

installed.

Power Unit Column

Shoulder Bolt

Slave Side Column

Electrical Safety

Shut

Off Switch

Padded Shut

Off Bar