Installation Guide

Asymmetric Pulley Configuration Continued….

The photo below illustrated the proper alignment and placement of the pulleys into

the overhead beam. Note that the outer pulley is positioned on the overhead

beam in the outer most axle holes and that it is closest to the front of the lift. The

inner pulley is positioned in the inner most axles holes and is mounted toward the

rearward area of the lift. When installing the opposite set of pulleys they must

correspond exactly as the first set of pulleys that you installed.

Symmetric Pulley Assemble shown on the following page

Note: Inner pulley is

facing to the rear of the lift

Note: Outer pulley is

facing to front of the lift