User's Manual

LAUNCH
S3001 User Manual
23
4. Connect the other end of the adaptor to the included S3001 VCI device.
5. To supply power to OBD I adaptor from:
A. Cigarette Lighter Cable: Connect one end of the cigarette lighter cable to
v
ehicle’s cigarette lighter receptacle, and the other end to the power jack o
f
O
BD I adaptor.
F
ig. 4-13
B. Battery Clamps Cable: Connect one end of the battery clamps cable to
v
ehicle’s battery, and the other end to the power jack of OBD I adaptor.
F
ig. 4-14
4.3.3 Vehicle connection (For Commercial Vehicle/ Gasoline & Diesel
Version)
The method used to connect the S3001 VCI device to a vehicle’s DLC depends
on the vehicle’s configuration as follows:
A. OBD II Vehicle Connection: Plug one end of the diagnostic cable into the
vehicle’s DLC, and the other end into the diagnostic socket of the S3001 VCI
device, and then tighten the captive screws.
F
ig. 4-12
B. Non-OBD II Vehicle Connection: For vehicles with non-OBD II diagnostic
socket, a non-16pin connector (adaptor cable) is required.