User's Manual
Table Of Contents
- User Manual
- 1 Introduction
- 2 Components & Controls
- 3 Preparations
- 4 Initial Use
- 5 Start Diagnostics
- 6 Maintenance Reset
- 6.1 Oil Reset Service
- 6.2 Electronic Parking Brake Reset
- 6.3 Steering Angle Calibration
- 6.4 ABS Bleeding
- 6.5 Tire Pressure Monitor System Reset
- 6.6 Gear Learning
- 6.7 IMMO Service
- 6.8 Injector Coding
- 6.9 Battery Maintenance System Reset
- 6.10 Diesel Particulate Filter (DPF) Regeneration
- 6.11 Electronic Throttle Position Reset
- 6.12 Gearbox Matching
- 6.13 AFS (Adaptive Front-lighting System) Reset
- 6.14 Sunroof Initialization
- 6.15 Suspension Calibration
- 6.16 EGR Adaption
- 6.17 Seats Calibration
- 6.18 Tyre Reset
- 6.19 Coolant Bleed
- 6.20 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
- 6.21 NOx Sensor Reset
- 7 Software Update
- 8 SmartLink Diag.
- 9 TPMS
- 10 ADAS
- 11 User Info
- 12 Others
- 13 J2534 Reprogramming Using SmartLink C
- 14 FAQ
- 15 Glossary of Terms & Abbreviations
- 页面提取自－User Manual
such as a device case and a device holster are not composed of metal components.
Keep your device 0 mm away from your body to meet the requirement earlier
mentioned.
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 0 mm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device should
not contain any metallic components. Body-worn accessories that do not meet
these requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or an approved antenna.