User's Manual
Table Of Contents
- User Manual
- 1 Introduction
- 2 Components & Controls
- 3 Preparations
- 4 Initial Use
- 5 Start Diagnostics
- 6 Maintenance Reset
- 6.1 Oil Reset Service
- 6.2 Electronic Parking Brake Reset
- 6.3 Steering Angle Calibration
- 6.4 ABS Bleeding
- 6.5 Tire Pressure Monitor System Reset
- 6.6 Gear Learning
- 6.7 IMMO Service
- 6.8 Injector Coding
- 6.9 Battery Maintenance System Reset
- 6.10 Diesel Particulate Filter (DPF) Regeneration
- 6.11 Electronic Throttle Position Reset
- 6.12 Gearbox Matching
- 6.13 AFS (Adaptive Front-lighting System) Reset
- 6.14 Sunroof Initialization
- 6.15 Suspension Calibration
- 6.16 EGR Adaption
- 6.17 Seats Calibration
- 6.18 Tyre Reset
- 6.19 Coolant Bleed
- 6.20 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
- 6.21 NOx Sensor Reset
- 7 Software Update
- 8 SmartLink Diag.
- 9 TPMS
- 10 ADAS
- 11 User Info
- 12 Others
- 13 J2534 Reprogramming Using SmartLink C
- 14 FAQ
- 15 Glossary of Terms & Abbreviations
- 页面提取自－User Manual
Safety & Accessory
Initial Use
Diagnostics
FAQ & Care
Product Prole
70
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
8. After the total progress reaches to 100%, the backup is OK. Unplug the storage device from the tablet.
Note: Another method is available for picture backup. User also can go to Gallery to select the desired folder/
les and share it to the external storage device via ES Save to....
14.2 About SmartLink Diag.
1. What network condition is required for SmartLink Diag.?
2. What does the word “Delay” displayed on the SmartLink C screen mean?
delay status. There are three states of network delay:
when the network delay is green. Otherwise, the communication with the vehicle may fail or the incorrect
system detection may occur.
disconnected.
3. Why is the network connection so poor?
4. Why does the sign
appear on the upper right corner of the SmartLink C screen?
is recommended to use the networks directly installed by telecommunication operators where there is no
5. Some systems of some old vehicles cannot be tested.
K-Line communication protocol.