User's Manual
Table Of Contents
- User Manual
- 1 Introduction
- 2 Components & Controls
- 3 Preparations
- 4 Initial Use
- 5 Start Diagnostics
- 6 Maintenance Reset
- 6.1 Oil Reset Service
- 6.2 Electronic Parking Brake Reset
- 6.3 Steering Angle Calibration
- 6.4 ABS Bleeding
- 6.5 Tire Pressure Monitor System Reset
- 6.6 Gear Learning
- 6.7 IMMO Service
- 6.8 Injector Coding
- 6.9 Battery Maintenance System Reset
- 6.10 Diesel Particulate Filter (DPF) Regeneration
- 6.11 Electronic Throttle Position Reset
- 6.12 Gearbox Matching
- 6.13 AFS (Adaptive Front-lighting System) Reset
- 6.14 Sunroof Initialization
- 6.15 Suspension Calibration
- 6.16 EGR Adaption
- 6.17 Seats Calibration
- 6.18 Tyre Reset
- 6.19 Coolant Bleed
- 6.20 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
- 6.21 NOx Sensor Reset
- 7 Software Update
- 8 SmartLink Diag.
- 9 TPMS
- 10 ADAS
- 11 User Info
- 12 Others
- 13 J2534 Reprogramming Using SmartLink C
- 14 FAQ
- 15 Glossary of Terms & Abbreviations
- 页面提取自－User Manual
Safety & Accessory
Initial Use
Diagnostics
FAQ & Care
Product Prole
54
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
A. For LAUNCH Wi-Fi mini printer, follow the steps below to connect the printer.
1. Tap Printer Set.
2. For initial use, you are suggested to reset the printer: Press and hold [MODE] & [FEED] for 8 seconds,
the following resetting command will be printed out:
ok
rebooting...
3. Tap Reset
Step 1: Connect the printer:
Tap Scan
Connect to enter Step 2.
Step 2: Join the Wi-Fi printer into LAN:
Tap Scan
Conrm.
4. Once the Wi-Fi network of the printer is connected and the printer is found, tap Printing test to test the
printing.
Now you can use the Wi-Fi printer to print!
check whether the current device and the printer are on the same LAN.
2. Tap Connect to Printer:
Test Print directly to test the printing.
Follow the steps below to proceed:
1. Set the default printer as System.
2. Go to Settings -> Network & Internet -> Wi-Fi
.