User's Manual
Table Of Contents
- User Manual
- 1 Introduction
- 2 Components & Controls
- 3 Preparations
- 4 Initial Use
- 5 Start Diagnostics
- 6 Maintenance Reset
- 6.1 Oil Reset Service
- 6.2 Electronic Parking Brake Reset
- 6.3 Steering Angle Calibration
- 6.4 ABS Bleeding
- 6.5 Tire Pressure Monitor System Reset
- 6.6 Gear Learning
- 6.7 IMMO Service
- 6.8 Injector Coding
- 6.9 Battery Maintenance System Reset
- 6.10 Diesel Particulate Filter (DPF) Regeneration
- 6.11 Electronic Throttle Position Reset
- 6.12 Gearbox Matching
- 6.13 AFS (Adaptive Front-lighting System) Reset
- 6.14 Sunroof Initialization
- 6.15 Suspension Calibration
- 6.16 EGR Adaption
- 6.17 Seats Calibration
- 6.18 Tyre Reset
- 6.19 Coolant Bleed
- 6.20 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
- 6.21 NOx Sensor Reset
- 7 Software Update
- 8 SmartLink Diag.
- 9 TPMS
- 10 ADAS
- 11 User Info
- 12 Others
- 13 J2534 Reprogramming Using SmartLink C
- 14 FAQ
- 15 Glossary of Terms & Abbreviations
- 页面提取自－User Manual
Safety & Accessory
Initial Use
Diagnostics
FAQ & Care
Product Prole
46
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
9.2 Operation Flowchart
Mercedes-BENZ
Steps Corresponding Screenshots
Step 1 - Tap TPMS on the diagnostic tool
Step 2 - Select the desired X-431 TSGUN
Note
：
This step shall apply when multiple
X-431 TSGUN devices are bound to the diagnosc
tool. If only one X-431 TSGUN is bound to the
diagnostic tool, keep the device ON and tap OK
to ignore this step. If it is your rst me using the
X-431 TSGUN, please bind it before doing any
TPMS operaons. See Chapter 9.3 for more details
on binding/unbinding.
Step 3 - Select target region
Step 4 - Select vehicle manufacturer